Warnings
A Warning message in AFT xStream alerts users to issues in the model that will affect the model results. These warnings often offer important information about the converged solution or the model itself, and should always be reviewed before considering the results to be meaningful for the system.
WARNINGS
-
Automatic sectioning did not achieve the desired steady conservation error.
-
Chempak temperature and/or pressure is out of range for the following
-
Inlet and outlet pipes at Junction X do not have the same stagnation enthalpy
-
Maximum system pressure exceeded enthalpy table's maximum pressure of X
-
Maximum transient pipe temperature significantly lower than estimate
-
MOC Steady solution did not reach a nominally steady state before transient
-
Physical flow area is less than the sonic area at junction X...
-
Pipe/Junction X property calculation exceeded maximum local iteration limit
-
Pipe/Junction X property calculation failed to continue towards convergenc
-
Pipe X temperature is outside temperature limits in AFT Arrow Steady Solution Control
-
Temperature is below the saturation line for the following. . .
-
Transient choking exists at junction X. The specified flow or pressure could not be met.
-
Transient data was extrapolated at Junction X