Cautions
A Caution message in AFT Fathom is of less importance than a full Warning. While some Caution messages may be left unresolved without affecting model results, they should never be ignored by the user.
CAUTIONS
-
Flow is negative through Junction X. Loss factors may be in error
-
Head rise across fixed flow pumps is referenced to system g level...
-
Junction X has a density change across it. If this is due to a moving interface...
-
Note: No scenarios have been set in the Multi-Scenario Output display
-
Pipe X elevation of Y is below Reservoir Z tank bottom elevation...
-
Pipe X length is shorter than the elevation change (between Junction Y and Z)
-
Pipe X segment length Y is shorter than the elevation change.
-
Pump X has no efficiency curve or nominal efficiency data...
-
The performance of Pump Junction XX may be affected by the fluid viscosity.
-
The System Life specified in Cost Settings is different from the XTS time
-
Velocity in pipe X is less than the deposition velocity (Velocity = Y, Vsm = Z)