Pump Sizing and Selection with Flow Control Valves - GSC
The piping for a heat exchanger system is being designed. The system will pump supply water from a tank pressurized to
Use the GSC module to size the pump.
Note: This example can only be run if you have a license for the GSC module.
Defining the Goal Seek and Control group
Using Pump head rise as a GSC Variable
Using Group Max/Min Goals
This example assumes the user has already worked through the Walk-Through Examples section, and has a level of knowledge consistent with the topics covered there. If this is not the case, please review the Walk-Through Examples, beginning with the Beginner: Three Reservoir Model example. You can also watch the AFT Fathom Quick Start Video Tutorial Series on the AFT website, as it covers the majority of the topics discussed in the Three-Reservoir Model example.
This example uses the following files, which are installed in the Examples folder as part of the AFT Fathom installation:
Step 1. Start AFT Fathom
From the Start Menu choose the AFT Fathom 12 folder and select AFT Fathom 12.
To ensure that your results are the same as those presented in this documentation, this example should be run using all default AFT Fathom settings, unless you are specifically instructed to do otherwise.
Step 2. Open the model
Open the Metric - Pump Sizing and Selection with FCV.fth example file and save it as a new file. We will not need the existing child scenarios for this example: right click on the Base Scenario in the Scenario Manager and select Delete All Children.
Set the J2 Pump Sizing Parameter to Head Rise, with a Fixed Head Rise of
If not already, set the J7 Control Valve to Flow Control (FCV) with a Volumetric Flow Rate Setpoint of
The workspace should look like Figure 1 below:
Step 3. Create a Group
Create a group named Flow Control Valves. Add both Control Valve junctions J4 and J7 to the group.
Step 4. Define the Modules Group
Open Analysis Setup, which should bring you to the Modules panel. Check the box next to Activate GSC. The Use option should automatically be selected, making GSC enabled for use.
Step 5. Define the Goal Seek and Control Group
Specify the variables and goals for the model.
Select the Variables panel in the Goal Seek and Control group. For this example, click New Variable and enter the following variable data:
Apply = Checked
Object Type = Junction
Junction Type = Pump
Junction Number and Name = J2 (Pump)
Variable Parameter = Head Rise
Link To = (None)
After entering the data, the Variables panel should appear as shown in Figure 2:
Select the Goals panel in the Goal Seek and Control group.
Create a new goal for the pressure drop across the flow control valves as defined below (if the option for a group goal is not visible, you may have forgotten to create a group as discussed above). Click New Goal and enter the following:
Apply = Selected
Goal Type = Group
Object Type = Group Max/Min
Goal Parameter = Pressure Loss
Criteria = >=
Goal Value = 0.35
Goal Units = bar
Object ID = Flow Control Valves
Object Location = NA
After entering the data, the Goals panel should appear as shown in Figure 3:
Step 6. Run the Model
Click Run Model on the toolbar or from the Analysis menu. This will open the Solution Progress window. This window allows you to watch as the AFT Fathom solver converges on the answer. This model runs very quickly. Now view the results by clicking the Output button at the bottom of the Solution Progress window.
Step 7. Examine the Output
The results of the GSC module analysis are shown in the General Output section. The GSC Variables tab shows the final value for the variable parameter, as shown in Figure 4. The pump head rise required for this system to supply a minimum of
Note that the results for this example are same as the results for the original Pump Selection with Flow Control Valves example.