The Transient Event/Design Alert did occur (at time X.XX seconds, step X). Only results before this time are displayed

An Information message in xStream

Full Message Text

Two variations are possible depending on the selection of Simulation Duration in Transient Control of the Analysis Setup Panel.

  • The Event ‘X’ did occur (at time X.XX seconds, step X). Only results before this time are displayed.

  • The Design Alert ‘X’ was hit (at time X.XX seconds, step X). Only results before this time are displayed.

Explanation

If the Simulation Duration is set to end based on a transient event or a design alert it will end the run if either one of them is achieved.

Required Action

The simulation will end and save the results from before the time step of the Event/Alert.

If a user is expecting the Event or Alert to stop the simulation, then the program will just state this message.

If a user is not expecting this then the user should make sure that the Transient Event and Design Alert are properly defined and are realistic to the system being used.

Related Topics

Simulation Mode/Duration Panel

The Transient Event/Design Alert did not occur so the simulation ended at the Maximum Time