Turn Off Parts of the Model
Using the Special Conditions feature, you can turn off elements in your model and, in effect, shut down entire sections. Then you can focus on getting selected sections to run to convergence.
If the model converges when some sections are closed, this suggests that there is an issue with the inputs in the closed sections.
Related Topics
Transfer Results to Initial Guesses
Poor Compressor/Fan Curve Fits
Troubleshooting Resistance Curves
Use the Output Window Sort Feature
Lower the Flow Rate Relaxation
Make Initial Flow Rate Guesses for Pipes
Break a Large Model Into Submodels
Try a Different Fluid, Equation of State or Accuracy Option
Using Lumped Adiabatic as a Starting Point
These results do not represent a converged solution. Use only for error resolution purposes